EK-HFB Fitting 10mm - Nickel

EK - 10mm - 1/4" BSPP (G1/4) High Flow Fitting is not just an ordinary 10mm spigot. This is a 10mm High Flow spigot, which means that its continuity hole is a lot bigger than normal fittings.

The EK 10mm spigot has an ID (Inner Diameter) throughout at 8mm ID. It?s the same size as the standard 12mm spigots.

EK-HFB Fitting 10mm - Nickel - (EAN: 3831109846728)

* 10mm High Flow fitting with the passage as a standard 12mm spigot
* 1/4" BSPP (G1/4) thread (can be used on many other brands)
* Made in funky shiny nickel-plated brass
* Hidden high quality O-ring
* Used for 10mm tubes
* ID (Inner Diameter): 8mm
* OD (Outside Diameter): 11mm
* Price per piece!

The connector has a delicious rubber O-ring, which means that the joint will be completely sealed. In this way you can also use the PTFE tape, which can be very cumbersome.

In order to provide the spigot a more complete appearance the O-ring will be invisible when you mount it.
The connector is made of nickel-plated brass which gives it a nice shiny appearance. Moreover, It?s equipped with two rings which ensure that the tube stays in place.

Since the fitting is made with 1/4" BSPP (G1/4) thread, it can be mounted in a variety of water cooler brands. For example: EK Water Block Alphacool, Laing, Black Ice Radiators, INNOVATEK, HTF, Heat Killer, D-Tek and many more!